Lines Matching refs:board

8 Boot the board into fastboot mode:
13 functionality may depend on the software installed on the board
20 * To manually boot the board into fastboot mode, press DOWN arrow
21   key over serial UART console when restarting the board.
25 * Disconnect the power *and* USB-C cable. Flip the board over, and
28   button. The board should then boot to fastboot mode. Be sure to
29   then re-connect the USB-C cable so that you can flash the board.
39 Flash the board:
41 Once the board is in fastboot mode, you can then flash it by
59 * If you cannot get the board into fastboot mode, or for some
61   a full recovery flash of the board using the following
80 binaries. After it is finished, the board will reboot.
82 Depending on the state of the board, it will enter fastboot