Lines Matching refs:P2P

23  * Interface exposed by the supplicant for each P2P mode network
101    * Set the postfix to be used for P2P SSID's.
114    * Set the Maximum idle time in seconds for P2P groups.
115    * This value controls how long a P2P group is maintained after there
117    * associated stations in the group. As a P2P client, this means no
147    * Initiate a P2P service discovery with an optional timeout.
162    * Stop an ongoing P2P service discovery.
174    * Flush P2P peer table and state.
185    * Start P2P group formation with a discovered P2P peer. This includes
200    *        Wi-Fi Peer-to-Peer (P2P) Technical Specification Version 1.7.
219    * Cancel an ongoing P2P group formation and joining-a-group related
221    * had been authorized to start group formation), stops P2P find (if in
223    * P2P group interface (if one was used) that is in the WPS provisioning
237    * Send P2P provision discovery request to the specified peer. The
238    * parameters for this command are the P2P device address of the peer and the
254    * Set up a P2P group owner manually (i.e., without group owner
272    * Terminate a P2P group. If a new virtual network interface was used for
341    * If the P2P module is not idle at the time the Extended Listen Timing
358    * Set P2P Listen channel.
378    * Set P2P disallowed frequency ranges.
491    * Schedule a P2P service discovery request. The parameters for this command
493    * wildcard query that is sent to every discovered P2P peer that supports
494    * service discovery) and P2P Service Query TLV(s) as hexdump.