Home
last modified time | relevance | path

Searched refs:cause (Results 1 – 25 of 95) sorted by relevance

1234

/hardware/knowles/athletico/sound_trigger_hal/tests/
Dcrash_analyzer.c72 char cause[64] = {0}; in find_exceptionin_cm4() local
90 strncpy(cause, "Reserved", sizeof(cause)); in find_exceptionin_cm4()
93 strncpy(cause, Cm4ExceptionCauseList[exceptionBitSet], in find_exceptionin_cm4()
94 sizeof(cause)); in find_exceptionin_cm4()
106 strncat(outbuf, cause, in find_exceptionin_cm4()
118 char cause[64] = {0}; in find_fatal_assert() local
161 snprintf(cause, sizeof(cause), "%s", in find_fatal_assert()
165 strncat(cause , "+", in find_fatal_assert()
166 sizeof(cause) - strlen(cause) - 1); in find_fatal_assert()
170 strncat(cause, lineNumStr, in find_fatal_assert()
[all …]
/hardware/interfaces/radio/1.5/
DIRadioIndication.hal47 * @param causeCode the primary failure cause code of the procedure.
50 * For LTE (EMM), cause codes are TS 24.301 Sec 9.9.3.9
51 * For NR (5GMM), cause codes are TS 24.501 Sec 9.11.3.2
53 * @param additionalCauseCode the cause code of any secondary/combined procedure if appropriate.
54 * For UMTS, if a combined attach succeeds for PS only, then the GMM cause code shall be
56 * For LTE (ESM), cause codes are in TS 24.301 9.9.4.4
/hardware/interfaces/sensors/2.0/multihal/tests/fake_subhal/
DREADME17 Take this .so and place it where the multi-HAL config will cause the HalProxy to
19 to cause the multi-HAL to restart and attempt to load in the sub-HAL.
/hardware/interfaces/graphics/bufferqueue/1.0/
DIGraphicBufferProducer.hal180 * also cause some buffer slots to be emptied. If the caller is caching the
199 * * this call would cause the maxBufferCount value to be exceeded.
220 * * this call would cause the maxBufferCount value to be
280 * * INVALID_OPERATION - cannot attach the buffer because it would cause
284 * buffer count was set and this call would cause
363 * this buffer would cause too many buffers to be simultaneously dequeued.
377 * * INVALID_OPERATION - cannot attach the buffer because it would cause
381 * buffer count was set and this call would cause
528 * IGraphicBufferProducer. Calling this method will cause any subsequent
/hardware/interfaces/camera/provider/2.5/
DICameraProvider.hal55 * cause any active camera device sessions to be closed, but may dynamically
/hardware/interfaces/sensors/1.0/
DISensors.hal83 * activated, in which case it must not cause any sensor measurements to
84 * be lost: transitioning from one sampling rate to the other cannot cause
/hardware/interfaces/radio/1.0/
DIRadio.hal254 * Requests the failure cause code for the most recently terminated call.
337 * fails. RadioError:SMS_SEND_FAIL_RETRY means retry (i.e. error cause is 332)
338 * and RadioError:GENERIC_FAILURE means no retry (i.e. error cause is 500)
353 * fails. RadioError:SMS_SEND_FAIL_RETRY means retry (i.e. error cause is 332)
354 * and RadioError:GENERIC_FAILURE means no retry (i.e. error cause is 500)
516 * @param cause: if success is false, this contains the failure cause as defined
522 SmsAcknowledgeFailCause cause);
1208 * This does not cause or change the rate of unsolicited cellInfoList().
1441 * using this request as it may cause some vendor modems to reset. Because
/hardware/interfaces/graphics/bufferqueue/2.0/
DIGraphicBufferProducer.hal35 * the consumer. Calling this may cause some buffer slots to be emptied. If
210 * If a dequeue operation shall cause certain conditions on the number of
288 * buffer would cause too many buffers to be simultaneously dequeued.
293 * See dequeueBuffer() for conditions that may cause the call to fail.
508 * Calling this method shall cause any subsequent calls to other
/hardware/interfaces/graphics/mapper/2.0/
DIMapper.hal139 * writing, the behavior is undefined, except that it must not cause
147 * outside of accessRegion is undefined, except that it must not cause
/hardware/qcom/display/msm8960/liblight/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/display/msm8996/liblight/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/google/av/media/codecs/amr_nb_wb/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/display/msm8909/libcopybit/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/sm8150/display/liblight/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/audio/visualizer/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/google/av/media/codecs/g711/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/display/msm8084/libgralloc/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/display/msm8994/libgralloc/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/google/av/media/codecs/vorbis/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/display/msm8084/liblight/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/sdm845/media/libstagefrighthw/
DNOTICE30 "control" means (i) the power, direct or indirect, to cause the
109 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/media/msm8996/libstagefrighthw/
DNOTICE30 "control" means (i) the power, direct or indirect, to cause the
109 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/bt/msm8996/libbt-vendor/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/sdm845/display/libcopybit/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices
/hardware/qcom/sdm845/display/liblight/
DNOTICE31 "control" means (i) the power, direct or indirect, to cause the
110 (b) You must cause any modified files to carry prominent notices

1234